steps on how do buld your own computer
step 1: unscrew 1 side of your computer case and take that side off completely.
step 2: screw your mother board to the base of your case sure all of your srew holes are lined up togeather.
step 3: once youre motherboard is screwed down properly then insert the processor CPU into the processor holder there is only 1 way it goes in dont force it cuz u will bend the pins make sure your pins are lined up with the holes to finish pull the silver or wat every colour leaver and that will then lock the processor in place.
step 4: attach your processor heatsink on top of your processor theres clips on the sides of you processor holder make sure your heatsink clips attach to the holder clips make sure its fanand down properly.
step 5: your processor heat sink shud cum with a cooling fan if not screw your cooling fan to the procsssor heatsink and attach the fan wire to the cpu fan adaptor on the motherboard its a 2 or 3 pin adaptor it will say cpu fan on the adaptor on the motherboard.
step 6: insert your ram/memory into its right holder its a long holder and at the end its got clips on make sure you buy the right ram for your motherboard theres 4 different types DDR,DDR1,DDR2 and DDR3 just ask a member of staff if you are unsure.
step 7: if you ave brought a new graphics board then in sert the graphics card into the PCI slot on the motherboard then theres a hole where u put the screw to securly fasen it up
step 8: do the same with with sound card if you have brought one
step 9: you have got a set of wire for your reset switch,on and off witch,hdd led,your power led theres a set of pins on the motherboard whereyou can put them insert them where they shud go
step 10: insert your hard drive into one on you hdd bays put swres in where the holes are and fasten them and then if its IDE put one end of the IDE cable into the back of the hard drive and the other end into the IDE socket on the mother and if the hard drive is SATA attach the SATA cable to the hard drive and the other endof the SATA to the SATA port on your mther board make sure your motherboard as got SATA compatibilites if no you will need a SATA to IDE or IDE to SATA converter adaptor